VAPE MOD KIT XYM-2 Standard

With Free 10ml Nasty Vape juice E-Liquid

1 x Gen Mod

1 x Gent Atomizer (Pre-installed 0.30hm coil 1 x Glass Tank

1x User Manual

1 x Micro-usb cable 1 x Warning card

VAPE MOD KIT XYM-2 Parameters

Height of the mod: 72 mm

Mod Width: 24mm Mod Length: 42mm

Tank diameter: 20mm

Tank capacity: 2ml Tank height: 45mm

Output power: 7W – 80W

Coil resistance: 0.30hm

Battery: Built-in 1600mAh battery

Thread: 510 Thread Low Voltage Protection

Short circuit protection Overuse protection

High temperature protection Low power protection

Attention

1 When the high temperature vapor enters a low temperature atomizer, it will produce condensation on the mouthpiece, which is a normal phenomenon. Just use a tissue to wipe and clean the mouthpiece, then use it again

2: If you do not useVAPE MOD KIT XYM-2, it is recommended to drain the atomizer, wipe off the condensate (which is not leaking liquid), and store it properly 3 SA leak is detected, it is likely that the atomizer coil and the top cover are not tight Please tighten the atomizer coil tightly or replace it with a new coil and tighten it then tighten the top cover So the leakage can be avoided When replacing the coil , please make sure the joints of the atomizer components are still in their original position 4 The-liquid is very consumable Please refill your atomizer in time when you run out of liquid to avoid burn

5 We recommend using a new coil when changing new e-liquid so that the old e-liquid does not affect the new taste 6 Make sure the tank is filled with e-liquid to the level 1/4 or more when using 7 Please stop using the device if you feel uncomfortable